Top-rated independent appliance repair across the Mid-South
A Burner That Clicks But Never Lights
A gas burner that won't light comes down to a plugged burner port, a bad igniter, or no gas getting there, and two of those you can check yourself in about ten minutes. You turn the knob, hear the hiss, and get click, click, click with no flame. Or no click at all, just quiet. Dinner sits on the counter going cold while you stand there listening.
Call (888) 857-9883- Real people on the phone
- 7 days a week
- Quote in writing before any work
Taking calls until 5:00 PM CT
Logan Appliance Repair service team · field-reviewed before publishing
What the symptom is actually telling you
A gas burner needs gas at the port, a spark to light it, and a clear path for both at the same moment. Pay attention to which one is missing. Clicking with no flame means the spark is fine and gas or the port is your problem. A gas smell with no clicking points at the igniter or the switch under the knob. No hiss and no click usually means power or supply. One burner acting up is a burner problem, and all of them at once is a shared part. That one detail saves a lot of guessing.
Spilled food and clogged ports, start here
This is the cheapest cause and the one we see most. Boil-over gravy, bacon grease, and pancake batter bake into the little holes ringing the burner head, so gas can't get out evenly and the burner lights on one side or not at all. You'll often see a lazy yellow flame crawling halfway around. Same story with the igniter tip, where a crust of dried food blocks the spark. Around here, cooktop vents also pull in fine clay dust that settles into everything. Cleaning is free and takes fifteen minutes. Try that before you call anybody, us included.
Ignition problems: weak spark, no spark, wet spark
The igniter is the little ceramic post beside the burner. If it clicks but the click sounds thin, or it clicks on the wrong burner, the spark module or the wiring is probably tired. Water is another culprit. After a heavy cleaning or a big steam pot, moisture in the igniter can make it click nonstop without lighting a thing. Give it a few hours to dry out. Storm-season power surges are hard on ignition modules, and we see plenty of cooktops that quit clicking the morning after a bad thunderstorm rolled through.
Gas supply and control valves
If nothing hisses when you turn the knob, gas isn't reaching the burner. Check the obvious first. Is the range knob turned all the way, is the gas on at the house, did anybody bump the shutoff behind the stove during a cleaning or a move. Propane tanks run out, too. Past that you're into the valve body and the safety valve, and that's technician territory. Do not take apart anything on the gas side. If you smell gas and it doesn't clear fast, shut the knob, open a window, step outside, and call your gas utility before you call anyone else.
Safe checks you can do, and where we take over
Here's the safe list: wipe the burner head and igniter tip with a dry brush, clear the port holes with a straightened paper clip, make sure the burner cap sits flat and seated, unplug the range for one minute and plug it back in, and confirm the wall outlet has power. That's it. Anything past that means panels, gas fittings, or live spark voltage. When we come out, we test the spark module output, check the safety valve, meter the switch under each knob, and look at whether a surge cooked the control board. We repair all major brands as an independent shop. Call us and tell us exactly what you hear when you turn the knob.
FAQ
Short answers to what folks ask us most on this one. If yours isn't here, call us and describe the sound and the smell. That's usually enough for us to know what part to bring.
A Burner That Clicks But Never Lights — common questions
Can I light a gas burner with a match if the igniter is dead?
On many older ranges, yes, briefly. But if gas flows without a working igniter, something in the safety chain may be off. Do it once to finish dinner if you have to, then get it repaired.
Why does one burner click when I turn a different knob?
Usually a shorted switch under the knob, or a wet spark module sending voltage down the wrong wire. That's an ignition fault, not a gas fault, and it needs testing behind the panel.
My burner lights, then goes out after a minute. What's wrong?
That points at the flame safety sensor. It has to feel heat to keep the valve open, so a dirty or failing sensor shuts the gas off as a precaution. Cleaning helps sometimes. Replacement often follows.
How it works
- Step 1
Tell us the symptom
Call us or fill out the form and tell us what you hear, smell, or see. Buzzing, leaking, no heat. Plain talk is fine. We'll ask a few questions and set a visit window.
- Step 2
We come look
A technician shows up in the window, pulls the unit out, and tests it. No guessing games. We explain what failed and why, in words that make sense on your back porch.
- Step 3
We fix it
Common parts ride with us, so a lot of repairs finish on that first visit. If a part has to be ordered, we tell you plainly and set the return date before we pull out of your driveway.
- A real person answers
- Open 7 days
- Written quote before work starts
Why homeowners call us
- Storm-season surge damageLightning and blinking power hurt control boards. You get an oven that lights up but won't heat, or a washer that quits mid-cycle. We test boards and wiring before we replace anything, so you know what the surge actually took out.
- Clay dust and lintRed clay dust and lint choke dryer vents and condenser coils. That's where long dry times and a hot laundry room come from, and it's why a fridge runs nonstop. We check airflow every visit, because a clogged vent kills a good machine slowly.
- Straight talk, no runaroundWe tell you what's wrong and what it takes to fix. If a machine is worn past sense, we say that too, and you decide. No pressure and no jargon. We don't dress up an upsell as advice.
- Independent and localWe're a Nashville crew, not a call center. As an independent shop we repair all major brands. Call us and you get a real person, somebody who knows the roads we drive.
- All major brands, gas & electricIndependent service on Whirlpool, LG, Samsung, GE, Maytag, Bosch, KitchenAid and the rest.
- Straight answersNot worth fixing? We say that out loud, and often it saves you the visit fee.
About this guide
Safe checks done and it still misbehaves? That's a real fault
Bring your notes from the checks to the call and booking takes no time.
- A real person answers
- Open 7 days
- Written quotes
- All major brands
- Gas & electric
Rather not call? Get a free quote →